Checking The Operation Of The 4285 Voice Module; To Check Voice Module Operation From An On-Pmmises Phones - ADEMCO Vista-20 Installation Instructions Manual

Checking the Operation of the 4285 Voice Module
To Check Voice Module Operation From an On-Pmmises Phones
1. Pick up phone and enter the programmed 2-digit phone code.
Annunciation of a systemstatus report should automaticallystart. See the
User's Guide accompanying the Voice Module for detailed information
regarding the nature of the status report, if necessary.
2. During any pause in the status report, or immediatelyfollowing it, key the
following via the keypad on the phone
Installer Code (4112),then press key 1 (OFF).
3. A %eep" should be heard on the phone and from a wired keypad, and the
words DISARMED,..READY TO ARM or DISARMED..iNOT READY
TO ARM* should be heard, indicating that the command was entered
successfully.
* DISARMED..NOT READYTO ARM wouldindicate en openzone.
4. Hangup the phone.
To Chack Voice Module Operation From au Off-Premises Phomx
1.
2.
3.
4.
5
6.
7.
8.
9.
Have som-conedial the premises phone number, using a TouchTone
phone.
If the phone system does not include an answering machine, 2 long
tones will be heard in the caller's phone, followed by a voice prompt
'HELLO, ENTER
PHONE CODE NOW'. The
caller should enter
the programmed 2-digit phone code.
If the premises phone system includes an answering machine, the 2-
digit phone codeshould be entered during a pause at the beginning of,
or during, the outgoingansweringmachine message.
When the 2-digit phone code is entered, the caller will hear a voice
prompt asking for entry of the 4-digit system code (WXVTER SYSTEM
CODE NOW).
The caller should then enter the installer code(4112). As a safety feature,
there is a 3-try limit in which to enter each code(phone codeand system
code), after which time the call-in will be aborted. Also, if no keys are
pressedfor a period of 20 seconds, the call-in will be aborted.
Annunciation of a system status report will start if both codes were
entered correctly.
During any pause in the status report, or immediately following it, the
caller should key the following via the keypad on the phone:
Installer Code (4112),then 1 (OFF).
A "beep"should be heard (and fkom a wired keypad on the premises), and
the words DISARMED...READY TO ARM or DISARMED...NOT
READY TO ARM* should be heard on the caller'sphone, indicating that
the commandwas enteredsuccessfully,
* DISARMED...NOTREADY TO ARM wouldindicate an openzone.
At this point, the callercan hangup the phone.
Verify with the caller that there was successfulaccess to the system and
that the appropriate annunciationswere heard over the phone.
If the Voice Module functioned satistktorily, unplug the AC transformer
fkomthe AC outlet.