Checking The Operation Of The 4285 Module - ADEMCO Vista-20HW Installation Instructions Manual

Checking the Operation of the 42?35 VIP Module
To Check Operation From an On-Premiees Phone:
1. Pick up phone and enter the programmed 2-digit phone code.
Annunciation of a system status report should automatically start. See the
User's Guide accompanying the 4285 module for detailed information
regarding the nature of the status report, if necessary.
2. During any pause in the status report, or immediately following it, key the
following via the keypad on the phone:
Installer Code (4112), then press key 1 (OFF).
3. A "beep" should be heard on the phone and from a wired keypad, and the
words DISARMED...READY TO ARM or DISARMED...NOT READY
TO ARM* should be heard, indicating that the command was entered
successfully.
* DISARMED...NOT READYTO ARMwouldindicatean open zone.
4. Hangup the phone.
To Check Operation From an Off-Premieee Phone:
1.
2.
3.
4.
5
6.
7.
8.
9.
Have someone dial the premises phone number, using a TouchTone
phone.
. If the phone system does not include an answering machine, 2 long
tones will be heard in the caller's phone, followed by a voice prompt
'!HELLO, ENTER PHONE CODE NOW". The caller should enter
the programmed 2-digit phone code.
Q If the premises phone system includes an answering machine, the 2-
digit phone code should be entered during a pause at the beginning of,
or during, the outgoing answering machine message.
When the 2-digit phone code is entered, the caller will hear a voice
prompt asking for entry of the 4-digit system code ("ENTER SYSTEM
CODE NOW').
The caller should then enter the installer code (4112). As a safety feature,
there is a 3-try limit in which to enter each code (phone code and system
code), after which time the call-in will be aborted. Also, if no keys are
pressed for a period of 20 seconds, the call-in will be aborted.
Annunciation of a system status report will start if both codes were
entered correctly.
During any pause in the status report, or immediately following it, the
caller should key the following via the keypad on the phone:
Installer Code (4112), then 1 (OFF).
A "beep" should be heard (and from a wired keypad on the premises), and
the words DISARMED...READY TO ARM or DISARMED...NOT
READY TO ARM* should be heard on the caller's phone, indicating that
the command was entered successfully.
* DISARMED...NOT READYTOARMwouldindicatean open zone.
At this point, the caller can hangup the phone.
Ve@ with the caller that there was successful access to the system and
that the appropriate annunciations were heard over the phone.
If the 4285 module fimctioned satisfactorily, unplug the AC transformer
from the AC outlet.