Motorola BSR 64000 Reference Manual page 661

Command Syntax
c2 hexnum
c2-exp hexnum
j0 hexnum
j0 16 byte string
j1 hexnum
j1 16 byte string
j1 64 byte string
s1 hexnum
Command Default
for c2, 0xCF
for j0, -xCC
for s1 0x0
path signal identifier used to identify the payload content type,
value is 0xCF for PPP or HDLC without scrambling;
0x16 for PPP or HDLC with scrambling
the section trace byte, value is 0x1 for interoperability with
some SDH devices in Japan
the section trace byte sequence, a character string of 15
characters may be entered for interface labeling. (The first byte
contains a calculated CRC-7 byte.
the path trace byte, default value of 0x0.
the path trace byte sequence, a character string of 15 characters
may be entered for STS Channel labeling. The last two bytes
are set to CR and LF for framing purposes
the path trace byte sequence, a character string of 62 characters
may be entered for STS Channel labeling. The last two bytes
are set to CR and LF for framing purposes.
for synchronous status messaging.
POS Commands
15-11