Show Cable Modem Stats - Motorola BSR 64000 Reference Manual

show cable modem stats

The show cable modem stats command displays the following statistics for each
cable modem on a CMTS module. This includes cable modems that are off-line.
Interface
Prim Sid
Connect State
Mac Address
Registration Time
TxBytes
RxBytes
Cable modem connectivity states are as follows:
init(r1)
init(r2)
init(rc)
dhcp(d)
dhcp(o)
dhcp(req)
dhcp(ack)
init(o)
init(t)
cable modem interface with active
connection
Primary Service Identifier number
describes the connectivity state of a cable
modem. The table below describes the 20
cable modem connectivity states
supported on the BSR.
cable modem Media Access Control layer
address
the length of time a cable modem has been
registered in ddd:hh:mm:ss format
the number of unicast bytes that have been
transmitted
the number of unicast bytes that have been
received
CM sent initial ranging parameters.
CM is ranging.
ranging is complete.
DHCP Discover was sent by CM.
DHCP Offer was received.
DHCP Request was sent by CM.
DHCP Ack was received, IP address was
assigned by DHCP server.
option file transfer was started.
Time-of-day (TOD) exchange was started.
CMTS Commands
13-121