Pos Signal Mode - Motorola BSR 64000 Reference Manual

pos signal mode

The pos signal mode command changes ports on the High Speed I/O Module (HSIM)
board to OC3-C or OC12-C
Use the pos signal mode command to change the ports on the HSIM board to either
OC3-C or OC12-C. If you select a mode that is already configured, it notifies the user
and does not reset the mode..
Note: To change to OC12-C mode, this command must be executed from
POS Interface 0.
When switched to OC12-C mode, all of the other three SONET ports are
disabled and are inaccessible through the CLI. The only way to access these
other three ports is to switch back to OC3-C mode.
Group Access
ISP
Command Mode
Interface Configuration
Command Line Usage
pos signal mode {oc3 | oc12}
Command Syntax
oc3
oc12
OC3-C mode, 155M
OC12-C mode, 622M
POS Commands
15-17