tunnel destination
The tunnel destination command provides a tunnel interface destination. The no
tunnel destination command removes a tunnel interface destination.
Note: The tunnel destination command specifies the endpoint of the tunnel.
If a hostname is specified, DNS must have already been configured. The host
name-to-address translation is done following the command only once. If
mapping changes occur, the command needs to be reissued and is stored as
an IP address in the configuration files.
Group Access
ISP
Command Mode
Interface Configuration (tunnel interface only)
Command Line Usage
tunnel destination {<address> | <hostname>}
no tunnel destination
Command Syntax
address
hostname
IP address of the tunnel interface destination
DNS name of tunnel interface destination
IP Commands
2-73