Cable Downstream Shutdown - Motorola BSR 64000 Reference Manual

cable downstream shutdown

The cable downstream shutdown command is used to disable an enabled
downstream port when certain downstream parameters require that the downstream
port is disabled before these parameters are configured.
The downstream port is disabled by default. Use the no cable downstream shutdown
command to enable the downstream port after the required downstream parameters
are configured for the BSR. The downstream port is not active for data transmission
until it is enabled.
Group Access
MSO
Command Mode
Interface Configuration
Command Line Usage
cable downstream [<port>] shutdown
no cable downstream [<port>] shutdown
Command Syntax
port
Command Default
The downstream port on the cable interface is disabled or "shut down" by default.
Downstream port number.
CMTS Commands
13-17