Chrysler PT Cruiser Service & Repair Manual page 1522

21 - 110 T350 MANUAL TRANSAXLE
T350 MANUAL TRANSAXLE (Continued)
(7) Line up reverse brake friction cone lugs to the
slots in the gear case (Fig. 53). Verify reverse brake
shim is in position.
Fig. 53 Friction Cone Lugs
1 - CASE
2 - FRICTION CONE LUGS
3 - INPUT SHAFT
(8) Position input and output bearings on the
shafts. Using Miller tool C-4992-1, press on input
and output shaft bearings until they bottom into the
case and against the shafts (Fig. 54).
Fig. 54 Installing Input and Output Bearings
1 - INPUT AND OUTPUT BEARINGS
2 - SPECIAL TOOL C-4992-1
(9) Install shaft snap rings at input and output
bearings (Fig. 55).
Fig. 55 Snap Rings Retaining Bearings
1 - SNAP RING PLIERS
2 - SNAP RINGS
(10) Apply Mopar RTV sealant to end–cover outer
edge and around bolt holes. Install end–cover onto
gear case. Tighten end cover bolts to 29 N·m (21 ft.
lbs.) torque (Fig. 56).
Fig. 56 Transaxle End Cover
1 - TRANSAXLE CASE
2 - END COVER
PT