Spark Plug Tube Seal Description; Removal; Installation - Chrysler PT Cruiser Service & Repair Manual

9 - 32 ENGINE 1.6L SOHC
CYLINDER HEAD COVER (Continued)
Fig. 31 Cylinder Head Cover Tightening Sequence
(3) Install ignition coil capacitor.
(4) Install ignition coil and spark plug cables.
Make sure the rubber insulators are in place on the
ignition coil (Fig. 32). Tighten ignition coil fasteners
to 12 N·m (105 in. lbs.).
Fig. 32 Rubber Insulators and Ignition Coil
1 - Rubber Insulators
2 - Coil
(5) Connect make-up air and PCV hoses (Fig. 28).
(6) Connect the ignition coil and capacitor electri-
cal connectors.
(7) Install upper intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE

INSTALLATION).

(8) Connect the negative battery cable.
SPARK PLUG TUBE SEAL
DESCRIPTION
der head cover (Fig. 33). These seals are pressed into
the cylinder head cover to seal the outside perimeter
of the spark plug tubes. If these seals show signs of
hardness and/or cracking, they should be replaced.

REMOVAL

ENGINE/CYLINDER
COVER - REMOVAL).
spark plug tube seals (Fig. 33). Care should be taken
not to damage cylinder head cover sealing surfaces.
1 - SPARK PLUG TUBE SEAL
2 - CYLINDER HEAD COVER
INSTALLATION
NOTE: Position seal with the concave side facing
the installation tool (Fig. 34).
(Fig. 34). Only hand pressure on tool is needed to
install new seals.
ENGINE/CYLINDER
COVER - INSTALLATION).
MANIFOLD -
The spark plug tube seals are located in the cylin-
(1) Remove the cylinder head cover (Refer to 9 -
(2) Using an appropriate tool, carefully remove
Fig. 33 Spark Plug Tube Seals
(1) Clean all sealing surfaces.
(2) Install seals using Special Tool MB-998306
(3) Install the cylinder head cover (Refer to 9 -
HEAD/CYLINDER
HEAD/CYLINDER
PT
HEAD
HEAD