Chrysler PT Cruiser Service & Repair Manual page 1945

PT
A/C EVAPORATOR (Continued)
(1) Separate the foam seals at the evaporator line
connection, and the dash panel air distribution out-
lets (Fig. 49).
(2) Disconnect fin sensing probe from harness.
(3) Remove upper to lower case retaining clip and
screws.
(4) Separate the case halves (Fig. 50).
(5) Lift the evaporator out of the module (Fig. 51).
Fig. 49 Lower HVAC Housing
1 - EVAPORATOR AND CONNECTION
2 - FOAM SEALS
3 - HEATER CORE AND TUBES
4 - HVAC HOUSING LOWER CASE
5 - HOUSING MOUNTING STUDS
6 - HOUSING DRAIN
7 - WIRING
8 - BLOWER MOTOR AND WHEEL
Fig. 50 Case Separation - Typical
1 - CASE HALVES
2 - EVAPORATOR
3 - BLOWER WHEEL
HEATING & AIR COND. - LHD
Fig. 51 Evaporator Removal - Typical
1 - EVAPORATOR
2 - BLOWER WHEEL
INSTALLATION
(1) Position the evaporator in the module.
(2) Close the case halves and install the retaining
clip and screws (Refer to 24 - HEATING & AIR CON-
DITIONING/DISTRIBUTION/HVAC
ASSEMBLY).
(3) Connect the fin sensing probe.
(4) Reposition the foam seals at the evaporator
line and the dash panel air distribution outlets.
(5) Install the heater-a/c housing (Refer to 24 -
HEATING & AIR CONDITIONING/DISTRIBUTION/
HVAC HOUSING - INSTALLATION).
(6) Evacuate the refrigerant system (Refer to 24 -
HEATING & AIR CONDITIONING - STANDARD
PROCEDURE).
(7) Recharge the refrigerant system(Refer to 24 -
HEATING & AIR CONDITIONING - STANDARD
PROCEDURE)
24 - 39
HOUSING -