Chrysler PT Cruiser Service & Repair Manual page 1571

PT
41TE AUTOMATIC TRANSAXLE (Continued)
(3) Remove battery (Fig. 10).
Fig. 10 Battery Removal/Installation
1 - BATTERY
(4) Remove battery tray (Fig. 11).
Fig. 11 Battery Tray Removal/Installation
1 - BATTERY TRAY
41TE AUTOMATIC TRANSAXLE
(5) Remove uppermost starter-to-transaxle bell-
housing bolt and remove transaxle dipstick & tube.
Plug hole to prevent debris from entering transaxle.
(6) Disconnect gearshift cable from manual valve
lever. Remove gearshift cable from trans mount
bracket and position cable out of the way.
(7) Disconnect cooler lines at transaxle and plug
holes to prevent debris from entering transaxle.
(8) Disconnect input speed sensor connector (Fig.
12).
(9) Disconnect output speed sensor connector (Fig.
12).
(10) Disconnect transmission range sensor connec-
tor (Fig. 12).
(11) Disconnect solenoid/pressure switch assembly
connector (Fig. 12).
Fig. 12 Component Connector Location
1 - SOLENOID/PRESSURE SWITCH ASSY. CONNECTOR
2 - INPUT SPEED SENSOR CONNECTOR
3 - OUTPUT SPEED SENSOR CONNECTOR
4 - TRANSMISSION RANGE SENSOR CONNECTOR
(12) Raise vehicle on hoist.
(13) Remove front wheel covers (if equipped) and
front wheel/tire assemblies.
(14) Remove left splash shield.
(15) Remove left and right halfshaft assemblies.
Refer to DIFFERENTIAL AND DRIVELINE for
proper procedures.
21 - 159