Chrysler PT Cruiser Service & Repair Manual page 1712

21 - 300 41TE AUTOMATIC TRANSAXLE
VALVE BODY (Continued)
(14) Install Manual
Transmission Range Sensor (Fig. 368).
Fig. 368 Install Manual Shaft/Rooster Comb and
Transmission Range Sensor
1 - TRANSMISSION RANGE SENSOR
2 - MANUAL SHAFT
3 - ROOSTER COMB
(15) Make sure Manual Valve control pin is con-
tained within the rooster comb slot (Fig. 369). Install
Transmission Range Sensor retaining screw (Fig.
369) and torque to 5 N·m (45 in. lbs.).
(16) Install manual shaft seal (Fig. 370).
INSTALLATION
NOTE: To ease installation of the valve body, turn
the manual valve lever fully clockwise.
(1) Guide park rod rollers into guide bracket while
installing valve body to the transaxle case (Fig. 338)
(Fig. 339).
(2) Install the valve
337)and torque to 12 N·m (105 in. lbs.).
(3) Install the oil filter (Fig. 336). Inspect the
o-ring for damage and replace as necessary.
(4) Install an 1/8' bead of RTV as shown in (Fig.
335)and install pan to case.
(5) Install oil pan bolts (Fig. 334) and torque to 19
N·m (165 in. lbs.) torque.
(6) Lower vehicle.
(7) Install manual valve lever to manual shaft
(Fig. 333).
(8) Install gearshift cable to manual valve lever
(Fig. 333).
(9) Install the battery tray (Fig. 332).
Shaft/Rooster Comb
body-to-case bolts
and
Fig. 369 Install Transmission Range Sensor
1 - TRANSMISSION RANGE SENSOR
2 - MANUAL VALVE CONTROL PIN
3 - RETAINING SCREW
(Fig.
Fig. 370 Manual Shaft Seal
1 - SEAL
2 - MANUAL SHAFT
(10) Install the battery and hold down clamp (Fig.
331).
(11) Install air cleaner assembly (Fig. 330).
(12) Connect battery cables.
(13) Fill transaxle with fluid. Refer to SERVICE
PROCEDURES for proper fluid fill procedure.
Retaining Screw
PT