Rear Door Glass - Chrysler PT Cruiser Service & Repair Manual

23 - 30 DOORS - REAR
REAR DOOR CHECK STRAP (Continued)
Fig. 5 REAR DOOR CHECK STRAP
1 - REAR DOOR UPPER HINGE
2 - REAR DOOR
3 - REAR DOOR CHECK STRAP
4 - REAR DOOR LOWER HINGE
(2) Install check strap attaching bolts to the door
end frame (Fig. 5) .
(3) Install check strap seal. If seal is damaged or
worn replace seal.
(4) Install check strap attaching bolts to the hinge
pillar.
(5) Install water shield and door trim panel.
REAR DOOR
REMOVAL
(1) Open door and support on a suitable lifting
device.
(2) Disconnect the wire connector at the hinge pil-
lar.
(3) Remove bolts attaching door check strap to
B-pillar.
(4) Mark door hinges for reinstallation.
(5) Remove bolts attaching lower hinge to door
(Fig. 5) .
(6) Remove bolts attaching upper hinge to door.
INSTALLATION
(1) Install bolts to the upper hinge to door (Fig. 5)
.
(2) Install bolts to the lower hinge to door.
(3) Connect the wire connector at the B-pillar.
(4) Remove lifting device.
(5) Install door check strap bolts.
(6) Adjust door as necessary.

REAR DOOR GLASS

REMOVAL
(1) Remove door trim panel and inner belt weath-
erstrip.
(2) Lower the window to 50 mm (2 ins.) from bot-
tom of travel.
(3) Loosen bolts attaching rear lower run channel
to inner door panel (Fig. 6).
(4) Remove rear run channels from door.
(5) Loosen screws attaching window regulator to
glass.
(6) Remove glass.
(7) Lift door glass upward out of the opening at
the top of door.
Fig. 6 REAR DOOR GLASS
1 - REAR DOOR WINDOW GLASS
2 - REAR DOOR
3 - REAR DOOR WINDOW POWER REGULATOR
INSTALLATION
(1) Lower door glass through opening in top of
door and into position in the window regulator (Fig.
6) .
(2) Raise window glass and regulator to full up
position.
(3) Tighten screws attaching window regulator to
glass.
(4) Install lower belt brackets.
(5) Install inner door belt door trim panel and
inner belt weatherstrip.
(6) Install outer belt weatherstrip.
(7) Operate window and check for interference.
Adjust glass as necessary.
PT