Chrysler PT Cruiser Service & Repair Manual page 1566

21 - 154 41TE AUTOMATIC TRANSAXLE
41TE AUTOMATIC TRANSAXLE (Continued)
DIAGNOSIS AND TESTING - ROAD TEST
Prior to performing a road test, verify that the
fluid level, fluid condition, and linkage adjustment
have been approved.
During the road test, the transaxle should be oper-
ated in each position to check for slipping and any
variation in shifting.
If the vehicle operates properly at highway speeds,
but has poor acceleration, the converter stator over-
running clutch may be slipping. If acceleration is nor-
mal, but high throttle opening is needed to maintain
highway speeds, the converter stator clutch may
ELEMENTS IN USE AT EACH POSITION OF SELECTOR LEVER
Shift Lever
Position
Underdrive
P - PARK
R - REVERSE
N - NEUTRAL
OD -
OVERDRIVE
First
Second
Direct
Overdrive
D - DRIVE*
First
Second
Direct
L - LOW*
First
Second
Direct
* Vehicle upshift and downshift speeds are increased when in these selector positions.
The process of elimination can be used to detect
any unit which slips and to confirm proper operation
of good units. Road test analysis can diagnose slip-
ping units, but the cause of the malfunction cannot
be determined. Practically any condition can be
caused by leaking hydraulic circuits or sticking
valves.
DIAGNOSIS AND TESTING - HYDRAULIC
PRESSURE TESTS
Pressure testing is a very important step in the
diagnostic procedure. These tests usually reveal the
cause of most hydraulic transaxle problems.
INPUT CLUTCHES
Overdrive
X
X
X X
X
X
X
X X
X
X
X X
have seized. Both of these stator defects require
replacement of the torque converter and thorough
transaxle cleaning.
Slipping clutches can be isolated by comparing the
"Elements in Use" chart with clutch operation
encountered on a road test. This chart identifies
which clutches are applied at each position of the
selector lever.
A slipping clutch may also set a DTC and can be
determined by operating the transaxle in all selector
positions.
Reverse
X
Before performing pressure tests, be certain that
fluid level and condition, and shift cable adjustments
have been checked and approved. Fluid must be at
operating temperature (150 to 200 degrees F.).
Install an engine tachometer, raise vehicle on hoist
which allows front wheels to turn, and position
tachometer so it can be read.
HOLDING CLUTCHES
2/4 Low/Reverse
X
X
X
X
X
X
X
X
X
X
PT