Chrysler PT Cruiser Service & Repair Manual page 1447

PT
G288 MANUAL TRANSAXLE (Continued)
(4) Raise transaxle with jack until mount bracket
pilots into upper mount. Access engine compartment.
Install and torque upper mount-to-transaxle bracket
bolts (Fig. 89).
Fig. 89 Upper Mount-to-Bracket
1 - BOLT (2)
2 - MOUNT
3 - BRACKET
(5) Remove transmission jack.
(6) Install starter motor into position. Install
ground cable and lower starter mounting bolt (Fig.
90).
(7) Install lower bellhousing bolt.
(8) Install two (2) intercooler connector pipe-to-en-
gine oil pan bolts (Fig. 91).
(9) Remove transaxle fill plug and add suitable
amount of ATF+4 (Automatic Transmission Fluid—
Type 9602). Torque fill plug to 39-47 N·m (29-35 ft.
lbs.). (Refer to 21 - TRANSMISSION/TRANSAXLE/
MANUAL/FLUID - STANDARD PROCEDURE)
G288 MANUAL TRANSAXLE
Fig. 90 Starter Bolt and Ground Cable
1 - GROUND CABLE
2 - BOLT
3 - STARTER MOTOR
Fig. 91 Intercooler Inlet Hose Fasteners
1 - INTERCOOLER INLET HOSE
2 - SCREW (2)
3 - STRUCTURAL COLLAR
21 - 35