Chrysler PT Cruiser Service & Repair Manual page 1196

9 - 176 ENGINE 2.4L DOHC
CYLINDER HEAD (Continued)
Fig. 23 Dipstick Tube
1 - DIPSTICK TUBE
2 - SCREW
Fig. 24 Lower Intake Manifold Support Bracket -
2.4L Turbo
1 - UPPER INTAKE MANIFOLD
2 - LOWER INTAKE MANIFOLD
3 - SUPPORT BRACKET
4 - DIPSTICK TUBE SCREW
• Remove elbow
Fig. 25 Turbocharger Brackets and Heat Shields
1 - UPPER/LOWER HEAT SHIELDS
2 - TURBOCHARGER SUPPORT BRACKET
3 - ELBOW
4 - ELBOW SUPPORT BRACKET
(15) Turbocharger equipped vehicles: (Refer to
11 - EXHAUST SYSTEM/TURBOCHARGER SYS-
TEM/LINES AND HOSES - REMOVAL) (Fig. 26).
• Remove oil return tube
• Remove oil supply line
• Remove coolant supply line
• Remove coolant return line
(16) Disconnect ignition coil wiring connector.
Remove ignition coil and plug wires from engine.
(17) Disconnect camshaft position sensor wiring
connector.
(18) Remove timing belt and camshaft sprockets
(Refer to 9 - ENGINE/VALVE TIMING/TIMING
BELT AND SPROCKETS - REMOVAL).
(19) Remove timing belt idler pulley and rear tim-
ing belt cover (Refer to 9 - ENGINE/VALVE TIMING/
TIMING BELT COVER(S) - REMOVAL).
(20) Non-Turbo equipped vehicles: Remove fas-
teners securing power steering pump fluid reservoir/
bracket to cylinder head.
(21) Remove cylinder head cover (Refer to 9 -
ENGINE/CYLINDER
COVER - REMOVAL).
(22) Remove camshafts (Refer to 9 - ENGINE/
CYLINDER HEAD/CAMSHAFT(S) - REMOVAL).
(23) Remove rocker arms.
(24) Remove cylinder head bolts in the reverse
sequence of tightening (Fig. 32).
(25) Remove cylinder head from engine block.
HEAD/CYLINDER
PT
HEAD