Left Mount; Right Mount Removal; Installation - Chrysler PT Cruiser Service & Repair Manual

PT
LEFT MOUNT (Continued)
Fig. 97 PDC Bracket Attaching Bolts
1 - PDC
2 - PDC BRACKET BOLTS
3 - BATTERY TRAY BOLT
Fig. 98 Left Mount
1 - BOLT

2 - LEFT MOUNT

3 - TRANSAXLE
4 - BOLT
ENGINE 2.4L DOHC
RIGHT MOUNT
REMOVAL
(1) Remove the engine assembly for the required
clearance to access the engine mount (Refer to 9 -
ENGINE - REMOVAL).
NOTE: The right engine mount attaching holes are
slightly oversize to compensate for manufacturing
tolerances. The mount has been set at the manufac-
turing plant for proper powertrain alignment. There-
fore, it is necessary to mark the position of the
mount before the attaching bolts are loosened.
(2) Using a permanent ink marker or equivalent,
mark the position of engine mount to the body frame
rail.
(3) Remove bolts attaching mount to body (Fig.
99).
(4) Remove mount.
Fig. 99 Engine Mount—Right
1 - SNUBBER PAD
2 - RIGHT ENGINE MOUNT
3 - BOLTS

INSTALLATION

(1) Position mount into the original position on
body frame rail (Fig. 99).
NOTE: Engine mount must be installed in the origi-
nal position on body frame rail. If mount was not
marked or frame rail was replaced, perform the fol-
lowing procedure.
(2) Perform the following procedure if the mount
position was not previously marked, or the frame rail
was replaced:
(a) Insert new mount loosely in frame rail.
(b) Align the four holes in the mount with the
mating holes in the rail such that the holes are
9 - 203