Chrysler PT Cruiser Service & Repair Manual page 1690

21 - 278 41TE AUTOMATIC TRANSAXLE
SPEED SENSOR - OUTPUT (Continued)
(3) Remove the battery hold down clamp and
remove the battery (Fig. 313) .
Fig. 313 Battery Removal/Installation
1 - BATTERY
(4) Remove the battery tray (Fig. 314) .
Fig. 314 Battery Tray Removal/Installation
1 - BATTERY TRAY
(5) Disconnect ouput speed sensor connector.
(6) Unscrew and remove output speed sensor (Fig.
315) .
(7) Inspect speed sensor o-ring (Fig. 316) and
replace if necessary.
Fig. 315 Output Speed Sensor
1 - OUTPUT SPEED SENSOR
Fig. 316 O-ring Location
1 - OUTPUT SPEED SENSOR
2 - O-RING
INSTALLATION
CAUTION: When disconnecting speed sensor con-
nector, be sure that the connector weather seal
does not fall off or remain in old sensor.
(1) Verify o-ring is installed into position (Fig.
316).
(2) Install and tighten output speed sensor to 27
N·m (20 ft. lbs.).
PT