Chrysler PT Cruiser Service & Repair Manual page 1816

23 - 88 SUNROOF
SUNROOF TROUGH GUIDE ASSEMBLY (Continued)
Fig. 9 TROUGH GUIDE REMOVAL
INSTALLATION
(1) Carefully twist trough guide through small slot
(cut out) on track to install (Fig. 9).
(2) Connect the trough guide wire to the lifter arm
(Fig. 8).
(3) Place the trough into position on sunroof.
Ensure that the trough crosses over the top of the
sunshade.
(4) Install the two screws that attach the trough to
the trough guides (Fig. 7). Tighten screws to 1 N·m
(9 in. lbs.) torque.
(5) Install sunroof glass panel (Refer to 23 -
BODY/SUNROOF/GLASS
TION).
DRAIN TUBE
REMOVAL
FRONT HOSES
(1) Move glass panel to the fully closed position.
(2) Remove sunroof opening trim lace (Refer to 23
- BODY/SUNROOF/OPENING
REMOVAL).
(3) Disconnect the control switch and wire connec-
tor.
(4) Remove headliner (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL).
PANEL - INSTALLA-
TRIM LACE
(5) Disconnect the drain hose from the sunroof
housing (Fig. 10).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Attach new drain hose to old hose with tape
that is to be replaced.
(8) Work the old hose back and forth to loosen the
sealer.
(9) Use care and pull the old hose out through the
bottom and the new hose through.
REAR HOUSING HOSE
(1) Move glass panel to the fully closed position.
(2) Remove sunroof opening trim lace (Refer to 23
- BODY/SUNROOF/OPENING
REMOVAL).
(3) Disconnect the control switch and wire connec-
tor.
(4) Remove headliner (Refer to 23 - BODY/INTE-
RIOR/HEADLINER - REMOVAL).
(5) Disconnect the drain hose from the sunroof
housing (Fig. 11).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Attach new drain hose to old hose with tape
that is to be replaced.
(8) Work the old hose back and forth to loosen the
sealer.
(9) Use care and pull the old hose out through the
bottom and the new hose through.
INSTALLATION
FRONT HOSES
(1) Connect the new drain hose to the sunroof
housing and test drainage (Fig. 10).
(2) Install headliner (Refer to 23 - BODY/INTERI-
OR/HEADLINER - INSTALLATION).
(3) Install sunroof opening trim lace (Refer to 23 -
BODY/SUNROOF/OPENING TRIM LACE - INSTAL-
LATION).
-
(4) Connect the control switch wire connector and
install control switch.
(5) Verify sunroof operation and alignment(Refer
to 23 - BODY/SUNROOF/GLASS PANEL - ADJUST-
MENTS).
PT
TRIM LACE -