Chrysler PT Cruiser Service & Repair Manual page 1609

PT
41TE AUTOMATIC TRANSAXLE (Continued)
(c) Remove oil pump o-ring (Fig. 148). Be sure
to reinstall oil pump o-ring after selecting the
proper #4 thrust plate.
(d) Install pump and gasket to transmission.
Install and torque bolts.
(e) Set up input shaft for measurement with
Indicator Set C3339 and End Play Set 8266 as
shown in (Fig. 149).
(f) Measure the input shaft end play with the
transaxle in the vertical position. Input shaft end
play must be within 0.005 to 0.025 inch. For
example, if end play reading is 0.055 inch, select
No. 4 Thrust Plate which is 0.071 to 0.074 thick.
This should provide an input shaft end play read-
ing of 0.020 inch which is within specifications.
(g) Refer to the No. 4 thrust plate chart to select
the proper No. 4 thrust plate:
Fig. 146 Select Thinnest No. 4 Thrust Plate
1 - OVERDRIVE SHAFT ASSEMBLY
2 - #4 THRUST PLATE (SELECT)
3 - 3 DABS OF PETROLATUM FOR RETENTION
Fig. 147 View Through Input Speed Sensor Hole
1 - INPUT CLUTCH RETAINER
2 - INPUT SPEED SENSOR HOLE
3 - OIL COOLER FITTINGS
41TE AUTOMATIC TRANSAXLE
Fig. 148 Remove Oil Pump O-Ring
1 - OIL PUMP ASSEMBLY
2 - O-RING
Fig. 149 Measure Input Shaft End Play Using End
Play Set 8266
1 - TOOL 8266–8
2 - TOOL 8266–2
3 - TOOL C-3339
NO. 4 THRUST PLATE CHART
PART NUMBER
4431665AB
3836237AB
4431666AB
3836238AB
4431667AB
21 - 197
THICKNESS
1.60mm (0.063 in.)
1.73mm (0.068 in.)
1.80mm (0.071 in.)
1.96mm (0.077 in.)
2.03mm (0.080 in.)