Specifications; 1.6L Sohc Engine - Chrysler PT Cruiser Service & Repair Manual

PT
ENGINE 1.6L SOHC (Continued)
Fig. 13 Positioning Engine - Removal/Installation
1 - SAFETY STRAPS
2 - SPECIAL TOOL 6710
3 - WOODEN BLOCK
4 - SPECIAL TOOL 6848
5 - PLACE REAR POSTS INTO LOCATING HOLES
(17) Connect power steering reservoir hose to
power steering pump. Install fastener securing power
steering return line to right engine bracket. Install
fasteners securing power steering reservoir bracket
to right engine bracket.
(18) Connect ground strap to cylinder head.
(19) Connect brake booster and purge solenoid vac-
uum hoses.
(20) Connect transmission shift cables and trans-
mission electrical connectors.
(21) Install cooling module assembly (fan, radiator,
A/C condenser). Connect radiator fan electrical con-
nector.
(22) Connect A/C lines at junction near upper
torque strut.
(23) Connect upper A/C line to A/C condenser.
(24) Connect upper and lower radiator hoses.
(25) Install upper radiator crossmember (Refer to
23 - BODY/EXTERIOR/RADIATOR CROSSMEMBER
- INSTALLATION).
(26) Connect heater hoses to thermostat housing
and heater return tube.
(27) Connect coolant recovery container hose to
radiator neck.
(28) Install bolts attaching Power Distribution
Center (PDC). Connect positive cable to PDC and
ground wire to vehicle body (Fig. 8).
(29) Connect engine wiring harness at Powertrain
Control Module (PCM).
(30) Install battery tray and battery (Fig. 6) and
(Fig. 7). Connect positive battery cable.
(31) Connect negative battery cable.
(32) Install air cleaner housing and throttle body
air inlet hose.
(33) Install new oil filter. Fill engine crankcase
with proper oil to correct level.
(34) Fill power steering system.
(35) Fill Cooling system (Refer to 7 - COOLING/
ENGINE - STANDARD PROCEDURE).
(36) Evacuate and recharge A/C system (Refer to
24 - HEATING & AIR CONDITIONING - STAN-
DARD PROCEDURE).
(37) Start engine and run until operating temper-
ature is reached.
(38) Perform torque strut adjustment procedure
(Refer to 9 - ENGINE/ENGINE
TORQUE STRUT - ADJUSTMENTS).
(39) Adjust transmission linkage, if necessary.

SPECIFICATIONS

1.6L SOHC ENGINE

DESCRIPTION
General Specification
Type
Number of Cylinders
Displacement
Bore
Stroke
Compression Ratio
ENGINE 1.6L SOHC
MOUNTING/
SPECIFICATION
In-Line OHV, SOHC
4
1.6 Liters
(97.6 cu. in.)
77.0 mm
(3.03 in.)
85.8 mm
(3.377 in.)
10.5:1
9 - 17