Oil Cooler & Lines - 2.4L Turbo Description; Removal; Installation - Chrysler PT Cruiser Service & Repair Manual

PT
OIL COOLER & LINES - 2.4L
TURBO
DESCRIPTION
An engine oil cooler is used on the 2.4L Turbo-
charged engine. The cooler is a coolant-to-oil type
and mounted between the oil filter and oil filter
adapter (Fig. 127).

REMOVAL

(1) Raise vehicle on hoist.
(2) Drain cooling system (Refer to 7 - COOLING/
ENGINE - STANDARD PROCEDURE).
(3) Disconnect oil cooler coolant hoses (Fig. 127).
(4) Remove oil filter.
(5) Remove oil cooler connector bolt (Fig. 128).
(6) Remove oil cooler.
Fig. 127 Oil Cooler and Lines
1 - COOLANT TUBES
2 - COOLANT HOSES
3 - OIL FILTER
4 - OIL COOLER

INSTALLATION

(1) Replace oil cooler seal (Fig. 129).
(2) Lubricate seal and position oil cooler to oil fil-
ter adapter, aligning notch to tab (Fig. 130).
(3) Install oil cooler connector bolt. Torque connec-
tor bolt to 55 N·m (41 ft. lbs.) (Fig. 128).
(4) Install oil filter.
(5) Connect oil cooler coolant hoses (Fig. 127).
(6) Lower vehicle.
(7) Fill cooling system (Refer to 7 - COOLING/EN-
GINE - STANDARD PROCEDURE).
ENGINE 2.4L DOHC
Fig. 128 Oil Cooler Connector Bolt
1 - OIL COOLER
2 - CONNECTOR BOLT
Fig. 129 Oil Cooler Seal
1 - OIL COOLER SEAL
9 - 215