Chrysler PT Cruiser Service & Repair Manual page 1410

19 - 64 PUMP
RESERVOIR (Continued)
Fig. 62 Hose Connection At Reservoir
1 - POWER STEERING FLUID RESERVOIR
2 - ENGINE COVER
3 - SUPPLY HOSE
4 - RETURN HOSE
Fig. 63 Power Streering Fluid Reservoir Mounting
1 - MOUNTING BOLTS
2 - POWER STEERING FLUID RESERVOIR
(6) Remove mounting bolts used to secure reser-
voir in place (Fig. 64). Remove reservoir.
Fig. 64 Power Steering Fluid Reservoir Mounting
INSTALLATION
INSTALLATION - 1.6L ENGINE
(1) Align the guide on the rear of the reservoir
with the mounting bracket and push reservoir down-
ward until reservoir clicks into place in the bracket.
(2) Install the supply hose onto the bottom of the
reservoir (Fig. 61). Slide the hose clamp into position
on the fluid reservoir and attach it. Be sure hose
clamp in installed past bead on fluid reservoir
fitting.
(3) Install the return hose onto the reservoir (Fig.
61). Slide the hose clamp into position on the fluid
reservoir and attach it. Be sure hose clamp in
installed past bead on fluid reservoir fitting.
(4) Fill the fluid reservoir to the proper level.
(Refer to 19 - STEERING/PUMP/FLUID - STAN-
DARD PROCEDURE - POWER STEERING FLUID
LEVEL CHECKING)
(5) Start the engine and let run for a few seconds,
then turn the engine off.
(6) Add fluid as necessary.
(7) Install the filler cap.
INSTALLATION - 2.0L/2.4L ENGINE
(1) Install the power steering fluid reservoir
bracket to the engine with mounting bolts (Fig. 63).
Tighten bolts to 10 N·m (90 in.lb.).
PT