Chrysler PT Cruiser Service & Repair Manual page 1921

PT
A/C HEATER CONTROL (Continued)
line, Control, and the Actuator Feed line. If not,
there is a blockage in the Actuator Feed line.
(8) If there is no blockage in the Supply line, Con-
trol, or the Actuator Feed line, the Actuator must
have failed. Connect the Vacuum hose from the Vac-
uum Test Gauge directly to the Actuator to verify the
Actuator has failed.
REMOVAL
(1) Remove the instrument panel center stack
bezel(Refer to 23 - BODY/INSTRUMENT PANEL/IN-
STRUMENT PANEL CENTER BEZEL - REMOVAL)
(Fig. 8).
Fig. 8 Instrument Panel Center Bezel & Knobs
1 - INSTRUMENT PANEL CENTER AIR DUCT
2 - OUTSIDE AIR/RECIRC CONTROL KNOB
3 - MODE CONTROL KNOB
4 - BLOWER SPEED KNOB
5 - TEMPERATURE CONTROL KNOB
(2) Remove the center air duct (Fig. 9).
(3) Remove the heater-A/C control head and dis-
connect the cable (Fig. 10).
INSTALLATION
(1) Connect the control head cable and install the
heater-A/C control head to the dash.
(2) Install the center air duct.
(3) Install the instrument panel center stack bezel-
(Refer to 23 - BODY/INSTRUMENT PANEL/IN-
STRUMENT PANEL
INSTALLATION).
CENTER BEZEL
HEATING & AIR COND. - LHD
Fig. 9 HVAC Center Air Duct & Control Head
1 - CENTER AIR DUCT
2 - INSTRUMENT PANEL
3 - HVAC CONTROL HEAD
4 - ATTACHING SCREWS
Fig. 10 HVAC Control Head Cables
1 - HVAC CONTROL HEAD
2 - ELECTRICAL CONNECTOR
3 - CONTROL CABLES
4 - VACUUM HARNESS
-
24 - 15