Using The Stack Bypass (Manual Feed Copying) - Canon NP6551 Operator's Manual

Using the Stack Bypass (Manual Feed Copying)

You can place up to approximately 50 sheets of copy paper [a stack approximately
(5mm) high] in the stack bypass to be automatically fed into the copier. Use the stack
bypass when you want to copy onto special copy stock, such as transparencies or labels, or
when the paper size that you want to copy on does not fit into a paper drawer.
Please note the following points when using the stack bypass:
■ 1
Paper size: 4 / " x 5
8
■
Paper weight: 17-lb bond to 110-lb index (64 to 200 g/m
paper weight that can be used varies depending on the Sorter being used.)
■
Curl down copy stock before use.
■
There are some types of copy stock which may meet the above specifications but
cannot be fed in the stack bypass.
NOTICE:
●
STMTR-size copy paper cannot be used to make two-sided or overlay copies.
●
Do not set different size paper at the same time.
MEMO:
●
If you want the copy stock placed in the stack bypass to be selected when using Auto Paper
Selection, you must enter the copy size before copying. (See p. 4-8.)
Place your originals.
■ For instructions on how to place an original on
the platen glass, see p. 2-17.
■ For instructions on how to place originals in
the RDF, see p. 2-18.
■
For instructions on how to place an original in
the SADF tray of the RDF, see p.2-19.
Program the copy settings. (See p. 2-4.)
1
1
/ " to 11" x 17"
8
2
) (However, keep in mind that the
3
/ "
16
2-29