Canon NP6551 Operator's Manual page 121

Select the size of the Originals, then press the
[OK] key.
MEMO:
●
When not using the RDF, place horizontal originals
(11"x17", LGL, LTRR, STMTR) on the platen glass.
Place the first original as in the figure on the right.
Press the [2 ON 1] key, then press the [OK] key.
3
Afterwards, press the [DONE] key.
Press the [PAPER SELECT] key to manually
4
select the copy paper size. (See "Manual Paper
Selection," on p. 2-24.)
NOTICE:
●
You cannot set Auto Paper Selection; manually
select a paper size (see p. 2-24).
MEMO: ●
The copier automatically selects the copy ratio
depending on the selected paper size (Auto Zoom).
Proceed to copy the first original.
(See "Making Copies," on p. 2-4.)
MEMO: ●
You can enter up to 50 copies for any one copy job.
After the first original has been copied, the
message shown as the right appears in the
touch panel display. Place the second original,
then press the
MEMO:
●
To cancel the settings, press the
(The copier returns to the Standard mode.)
3-24
key again.
Start
Reset
key.