Press the [BIND. ERASE] key, then press the
2
[OK] key.
Specify the frame erase width [
3
~
(1
20 mm)], then press the [OK] key.
Use the [+] and [–] keys to set the frame erase
width.
• Press the [+] key to increase the width of the
frame.
• Press the [–] key to decrease the width of the
frame.
• Press the [mm] key to enter in millimeters.
MEMO:
●
The default setting for the frame erase width is
(18 mm).
●
Using the "Inch Entry" in the Additional Functions
mode, you can set the copier so that entry can only
be done in millimeters.
In this case the [INCH] key is not displayed.
After you have finished making the settings,
press the [DONE] key.
Proceed to copy in the usual manner.
(See "Making Copies," on p. 2-4.)
MEMO:
●
To cancel the settings, press the [SPECIAL
FEATURES], [FRAME ERASE], and [C] keys in that
order.
●
You can also cancel the mode by pressing the
key. (The copier returns to the Standard mode.)
3-8
1
3
/
"-
/
"
8
4
3
/
"
4
Reset
Millimeter Entry key