Self-Diagnostic (Error) Messages - Canon NP6551 Operator's Manual

Self-diagnostic (Error) Messages

Self-diagnostic (error) messages appear in the touch panel display at the following times:
■ When copying cannot be performed because of an operational error.
■
When you need to make a judgment or take some action during the copying process.
If a self-diagnostic message appears, follow the instructions in the touch panel display.
Messages which require further explanation are described below.
Message/Cause
Load LTR-size paper.
A paper drawer loaded with the most
appropriate paper size is not inserted in
the copier.(Appears when using Auto
Paper Selection.)
Part of the image will not be
reproduced on the copy.
The entire original image does not fit on
the selected paper size, even if reduced
with the minimum copy ratio (49%).
(Appears when Auto Zoom is set.)
Return pg. 1 to the top and
press the Start key.
Copying was stopped due to a problem
with the RDF.
Remove paper from the sorter
and press the Start key again.
Copies from the previous copy job
remain in the Sorter.
7-2
Remedy
Load the indicated paper size in a paper
drawer.
● If you press the
message appears, copying is performed
with the currently selected paper size.
Program the copy settings again.
● If you press the
message appears, part of the original
image is cut off.
Arrange the originals in page order with
the first page on top. Place the originals
back in the RDF original tray, then press
the key.
Start
Remove the copies from all of the bins,
then press the key.
Start
key while this
Start
key while this
Start