Fit Image Adjustment - Canon NP6551 Operator's Manual

■

Fit Image Adjustment

The Fit Image mode selection can be changed and
registered.
• Copy ratio:
• Center shift:
• Lose bit of image: If copies made with the Fit Image
Select FIT IMAGE ADJUSTMENT.
Set each:
1
Copy Ratio
Set the ratio by pressing the [+] and [–] keys.
Center Shift
Select the [ON] or [OFF] key.
Lose Bit of Image
Select the [ON] or [OFF] key.
When all the settings are finished, press the
[OK] key.
MEMO:
●
The copy ratio can be set from 90% - 99% in 1%
increments. Note that even if you set "LOSE BIT OF
IMAGE" to "OFF," the image may be cut off if the
ratio is set to enlarge.
●
Usually when copying, a few inches(millimeters)
around the edges of originals are not copied and
may appear blank on copy sheets.
If the Fit Image mode has been selected with the
default value (Lose Bit of Image OFF), the image on
the original will be completely scanned from edge to
edge. By slightly reducing the original's image and
copying it, there will be no missing parts in the copy.
However, if the reduction ratio is increased, the
image is completely scanned but some parts of the
original image may be cut off.
●
The default settings for the Fit Image mode are as
follows:
• Copy Ratio:
• Center Shift:
• Lose Bit of Image: OFF
●
When Center Shift is "OFF" the Fit Image mode can
be specified together with the Margin mode.
●
Even if Center Shift is set to "ON," it may not take
effect, depending on the size of the image and copy
paper. In this case, the copy will be made so that
there will be a blank area of up to
right of the copied image.
4-12
Changes how much copies are
reduced.
Set to "ON" to shift the copied image
to the center of the paper.
mode have shadows or lines around
them, set this to "ON".
93%
ON
3
/
4
"(20 mm) to the
ABC
Up to
3 / 4 "