Canon NP6551 Operator's Manual page 54

Job Duration Display function
When the Job Duration Display is set to ON in
Additional Functions and the appropriate modes
are set, the remaining time necessary to
complete the copy job can be displayed. Job
Duration can only be displayed when the
following modes are set. (However, this function
cannot be used in combination with the Different
Size Original mode.)
1→1-sided
1→2-sided*
2→1-sided
2→2-sided
Book→2-sided
* When copying originals on the platen glass, the
Job Duration Display message appears
individually for each original since originals must
be placed one at a time.
■
When using the Interrupt mode
Interrupt
If the key is pressed, the Job Duration Display
message disappears. Once the copy job using the
Interrupt mode begins, the time necessary for it to
be completed is displayed. After the Interrupt mode
has been canceled and the
pressed to restart the previous copy job, the
previous Job Duration Display message returns.
■ When paper jam or paper loading messages
appear in the display
The Job Duration Display countdown will stop.
Once the instructions displayed in the error
message have been carried out, press the
and the Job Duration Display countdown will
continue.
■
When using Unlimited Sorting
The necessary time interval between each round of
copies is displayed.
MEMO:
●
Job Duration Display can be set to ON or OFF in
Additional Functions. (See "Job Duration Display,"
on p. 4-10.)
●
The time displayed is only a rough estimate.
Depending on the modes that are set and the
conditions of use, the time displayed may differ from
the actual time.
Two-page Separation
2 ON 1*
2 ON 1/Two-sided
Cover/Sheet Insertion
key has been
Start
Start
key
2-15