Inch Entry; Job Duration Display - Canon NP6551 Operator's Manual

■

Inch Entry

This function displays an Inch Entry key so that in modes
where numerical entry is performed, inches as well as
millimeters can be entered.
ON: mm/inch (both can be entered)
OFF: mm entry only
●
MEMO: Inch Entry can be performed in the following modes.
• Margin (setting the width of the margin)
• Frame Erase (setting the width to be erased for
the binding holes)
• Zoom Program (setting the ratio)
●
The default setting is "INCH ENTRY: ON."
Select the [ON] or [OFF] key, then press the
[DONE] key.
●
MEMO: The default setting is "INCH ENTRY: ON."
■

Job Duration Display

When Job Duration Display is set to ON and the
appropriate modes are set, the remaining time necessary
to complete the copy job can be displayed.
ON: When the appropriate modes are set, Job Duration
can be displayed.
OFF: Job Duration cannot be displayed.
Job Duration can only be displayed when the following
modes are set. (However, this function cannot be used in
combination with the Different Size Original mode.)
1→1-sided
1→2-sided
2→1-sided
2→2-sided
Book→2-sided
●
MEMO: The default setting is "Job Duration Display: OFF."
●
The time displayed is only a rough estimate.
Depending on the modes that are set and the
conditions of use, the time displayed may differ from
the actual time.
Select the [ON] or [OFF] key, then press the
[DONE] key.
●
MEMO: The default setting is "Job Duration Display: OFF."
4-10
Two-page Separation
2 ON 1
2 ON 1/Two-sided
Cover/Sheet Insertion