Canon NP6551 Operator's Manual page 47

In general, you should use originals which are
all the same size.
When the Different Size Original mode is set
(see p. 3-39), you can feed different-size
originals together in one group. The leading
edge of each page must be the same length and
the originals must all be the same thickness.
The following sizes can be fed together:
• LTR and 11" x 17" • STMT and LGL
• STMT and LTRR
• STMT, LTRR, and LGL
Place the originals as shown in the figure to the
right so that the edges which will enter the
copier first are all the same length.
NOTICE: ●
When feeding different-size originals in the RDF,
select Auto Paper Selection.
Place originals in page order with the first page
on top. Whether using vertical or horizontal
placement, align the top edges of the originals
with the back edge of the original tray.
Place STMT-size originals vertically. You can
place LTR-size originals either vertically or
horizontally.
NOTICE: ●
After copying begins, do not add or remove
originals.
MEMO:
●
You can place up to 50 LGL or 11"x17"-size
originals (20-lb bond) in the original tray. You can
place up to 100 STMT, LTR or LTRR size originals
(20-lb bond) in the original tray.
Program the copy settings.
3
MEMO:
●
Press the Number keys (
quantity. (See "Entering the Copy Quantity," on p.
2-20.)
●
Press the [DARK] and [LIGHT] keys to adjust the
copy exposure. (See "Adjusting the Copy
Exposure," on p. 2-21.)
●
Press the [PAPER SELECT] key to select the copy
paper size. (See "Selecting the Copy Paper Size, "
on p. 2-22.)
●
Press the [REDUCE] and [ENLARGE] keys to select
a preset copy ratio. (See "Using Preset Copy
Ratios," on p. 2-40.)
2-8
• LTRR and LGL
- ) to enter the copy
1
0
Leading edge
length
LTR
Original feeding direction
Leading edge
length
LTRR
STMT
Original feeding direction
Reset
Guide
Additional Functions
Interrupt
11"x17"
LGL
Display Contrast Energy Saver
Stop
Clear
Start