Canon NP6551 Operator's Manual page 85

Press the [ZOOM PROGRAM] key.
2
Enter the original size and the desired copy size
3
with the Number keys ([1] – [0]) in the display.
You can switch between the original size and
copy size settings by pressing the [ORIGINAL
SIZE] and [COPY SIZE] keys.
For example, to make a 3
7
5 / " (150 mm) original, program the settings as
8
shown in the display on the right.
Press the [mm] key to enter in millimeters.
MEMO:
●
When the copier calculates a copy ratio at less than
49%, it sets the copy ratio to 49%. When the copier
calculates a copy ratio at more than 204%, it sets
the copy ratio to 204%.
●
Copy ratios are calculated as follows:
copy ratio (%) = (copy size ÷ original size) x 100
●
If you enter an incorrect value, press the [C] key and
enter the value again.
●
Using the Inch Entry under Additional Functions,
you can set the copier so that entry can only be
done in millimeters.
In this case the [INCH] key is not displayed.
●
Enter [1] [–] [1] [/] [2] for 1-
2-46
1
/ " (80 mm) copy of a
8
1
/ ".
2