Specify the margin width [0" -
3
then press the [OK] key.
Use the [+] and [–] keys to set the width of the
margin.
• Press the [+] key to increase the width of the
margin.
• Press the [–] key to decrease the width of the
margin.
• Press the [mm] key to enter in millimeters.
MEMO:
●
The default setting for the margin width is
●
Using the "Inch Entry" in the Additional Functions
mode, you can set the copier so that entry can only
be done in millimeters.
In this case the [INCH] key is not displayed.
After you have finished making the settings,
press the [DONE] key.
Proceed to copy in the usual manner.
(See "Making Copies," on p. 2-4.)
MEMO:
●
To cancel the settings, press the [SPECIAL
FEATURES], [MARGIN], and [C] keys in that order.
●
You can also cancel the mode by pressing the
key. (The copier returns to the Standard mode.)
~
3
/
" (0
20 mm)],
4
3
/
" (10 mm).
8
Reset
3-13