Connecting The Ip Ts Output - Cisco D9854 Installation And Operation Manual

Connecting the IP TS Output

The Ethernet Interface
The RJ-45 interface IP TS OUT is 10/100/1000 BASE-T Ethernet. It is intended for
both MPEGoIP and MPE outputs. The MPEGoIP output of the transport stream is
encapsulated in the IP packets to a groomer (e.g., Digital Content Manager 9900) for
distribution. The MPE output receives IP packets from the transport stream.
Informative Notes
For reliable Ethernet operation; to run over a maximum segment length of 100 m
and up to 100baseT, the cable has to comply with the EIA/TIA Category 5 (or
higher) wire specifications, and for 1000baseT, Category 6 is required.
To Connect the Ethernet Interface
1. Connect a crossed RJ-45 cable between the Ethernet connector on the D9854
receiver and the Ethernet port of the equipment after the D9054 HDTV Encoder.
The equipment after the D9854 receiver could be an IP router or a switch.
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 3-11