Cisco D9854 Installation And Operation Manual page 105

Setup Menu: Services,
VIDEO
PV Format
Description:
Parameters:
Stream
Description:
SD Format
Description:
Parameters:
SD Output
Description:
Parameters:
Bitrate
Description:
Parameters:
Tri-Synch
Description:
Parameters:
Alarm Video Cutoff
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Indicates the output video format. This value is read-only.
Auto, SD, HD 720p, or HD 1080i.
This is the format of the incoming stream. It is determined by the
the SD Format setting and the actual format of the incoming stream.
This value is read-only.
Selects the video format for the output when the input video is SD
format.
Auto, NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D. Use NTSC for
525-line systems and PAL-B/G/I/D for 625-line systems.
Indicates the SD Output video signal format.
NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D.
Indicates the video output bit rate.
1.0 to 15.0 Mbps.
Indicates whether component Tri-Synch is enabled or disabled.
Enabled or Disabled.
Sets whether the video output is cut off if any enabled alarm is
active on the receiver. When video is cut off, there will be no
horizontal or vertical synchronization on the output. This is useful
for downstream redundancy switching by detecting a loss of video
signal.
Note: This same function also exists under Setup: Alarm/Warning.
Enable or Disable. The default is Disable.
4-43