Configuring The Transport Stream: Dpm Asi/Mpeg Details - Cisco D9854 Installation And Operation Manual

Configuring the Transport Stream: DPM ASI/MPEG Details

To Set up the DPM ASI/MPEG Details
Proceed as follows to set up the DPM ASI/MPEG Details:
Note: The following procedure defines all the available fields. For a typical setup of
the DPM, see Typical set up for Digital Program Mapping (DPM), page 5-42.
1. From the user interface of the D9854, click the Setup tab and then click the
TSOutput icon from the sub-page and select DPM ASI Details or DPM MPEG
Details radio button.
2. For each DPM program entry (PE), it displays the input Channel # and Channel
Name.
Note: Any changes made to the DPM ASI/MPEGoIP Program Entry
configuration automatically changes the Output Mode to Full DPM Control in
the Transport Stream Configuration page.
When you initially make a change, the page refreshes and the Transport Stream
Configuration page appears with the Output Mode changed to Full DPM
Control. Click Save and continue to edit the DPM ASI/MPEGoIP PE
parameters.
3. In the Action drop-down, select the DPM program action for the PE (Pass, Map,
or Drop). The default is Pass.
4. Enter the DPM Output channel you want to map to the input channel (Channel
#). This value is only used if the PE Action is set to Map. You can enter a range
from 1 to 65535.
5. Each PE output can be synchronized to its input according to one of the four
output modes. Click All to synchronize services and PIDs, Svc to synchronize
services only, Template to synchronize using a template, or PIDs to synchronize
using PIDs only.
6. Click Save.
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 5-39