Cisco D9854 Installation And Operation Manual page 96

Setup Menu: TS Input,
E/W
Description:
Parameters:
Pol
Description:
Parameters:
Validate Orbital Position
Description:
Parameters:
Orbital Position Validation Date
Description:
Parameters:
Freq (GHz)
Description:
Parameters:
SymRate
Description:
Parameters:
FEC
Description:
Parameters:
4-34 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Denotes the satellite position the dish connected to the current RF
Input should point. This is used when the satellite is not available in
the look-up menu list.
E, W or NA.
Marks the polarity of the signal connected to this RF input.
H (horizontal), Vert (vertical), A (Auto). Auto is only applicable for
This setting is only applicable when LNB Power is set to H-NIT or
V-NIT.
This option allows you to configure and validate the RF inputs to
match those expected by the network. The receiver will check to see
if all the frequencies in the Network Information Table (NIT) can be
tuned to.
Yes or No.
This displays the last date that the 'Validate Orbital Position'
operation was performed.
N/A.
This is the current Downlink operating frequency used by the
receiver for tuning the received digital signal.
0.0 to 15.0 GHz.
This is the symbol rate. The symbol rate must match that of
transmitted signal.
1.0 to 45.0 Ms/s for DVB-S.
1.0 to 30.0 Ms/s for DVB-S2 if Pilot Present is set to Yes.
5.0 to 30.0 Ms/s for DVB-S2 if Pilot Present is set to No.
This is the Forward Error Correction inner code rate. The FEC must
match the FEC of the transmitted signal.
1/2, 2/3, 3/4, 5/6, 7/8 for DVB-S or Auto for DVB-S2.
4021470 Rev D