Setup Menu: Outputs - Cisco D9854 Installation And Operation Manual

Setup Menu: Outputs

Structure
To view the Outputs menus from the Main menu, press the RIGHT arrow key once
and then the SELECT key to reach the Setup menu. Then press the RIGHT arrow
key four times and the SELECT key to view the Outputs menu.
The Outputs menu allows you to set up the rear panel control relays for alarms, cue
tones and cue triggers, and the transport stream outputs, Digital Program Mapping
(DPM) and transcoding.
For instructions on how to select and store settings, see About the Front Panel,
page 4-2.
The Outputs menu has the following structure:
Main:Setup:Outputs
Cueing TS Out M1/M2
Cueing
Cueing Mode Trigger Polarity
Trigger High
Repeat Tone(ms) Silence(ms)
3 40 40
Seq# State Tones Mode Delay(sec)
16 Disable 999 */# 255
Relay Mode Cue Trigger Bit
Trigger 1
Cue Tone Test Mode Run Test
999 */#
M1/M2
4-62 Model D9854 Advanced Program Receiver Installation and Operation Guide
i s
i s
ASI
Name Rate Control User Rate(Mbps)
i s ASI User
Output Mode
i s MAP Svc Chans Only Descrambled
Insert Null Packet
i s
Yes
i s
M1 Port Type M2 Port Type
ASI SDI
Main:Setup:Outputs:TS Out
ASI MOIP1 DPM
i s
213.0
Descramble Mode
i s
i s
i s
SDI Only
i s
MOIP1
Name Rate Control User Rate(Mbps)
MOIP1 User 213.0
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
Insert Null Packet
Yes
Instance Name
MPEG over IP 1
MOIP Send SAP SAP ID
RTP Yes Channel Name String
DestAddr UDPPort SrcPort
192.131.244.111 12345 12345
TS/IP Min IP/s PCR@IP Start
8 1000000 Yes
MGMT Port Mode DATA Port Mode
Always Output Always Output
SAP Multicast Address PCR Addition
192.131.244.123 Yes
4021470 Rev D
i s
i s
i s
i s
i s
i s
i s
i s
i s
MOIP Only