Cisco Rainier Satellite D9865 Quick Tips

RAINIERCISCOCOMMERCIALD9865 D - H - B RECEIVER QUICKTIPS.
PLEASE READ DOCUMENT FULLY BEFORE ATTEMPTING TO PROGRAM DATA.
 Pre-setup Procedure
Connect with RG6u 1450 mhz or better jumper cable using compression connectors to the receiver.
Connect from either Rainier approved Diseqc switch (9865 to power the LNB's) or Rainier approved
high block splitter (using the D9865 receiver as a slave, using master receiver to power the LNB. 18-
21 volts DC must be obtained by master receiver for both polarities. Please verify to ensure proper
operation). Low cost or knockoff Diseqc switches or high block splitters can cause signal issues.
Always use genuine Rainier approved parts available at our store.
Put batteries in the remote control.
1)
Power on the unit with the toggle switch on the back and bottom right of the unit.
2)
Power on your television set and move on to setup procedure.
3)

Receiver Setup Procedure
•
Administration Procedure
Press "Menu" Button on remote.
1.
Go to "Setup Menu", and press "ok" on remote.
2.
Go to "Advanced Setup", press "ok".
3.
Go to "Administration", press "ok".
4.
Go to "POV Mode", press "ok", and set to "Open" with arrow keys on the left and right of
5.
"ok", and press "ok".
Go to "Date Format", press "ok", set to "DD/MM/YYYY", and press "ok".
6.
Go to "Time Format", press "ok", set to "12 Hr", and press "ok".
7.
Go to "Time Offset"; press "ok"; set to "-5:00" for Eastern, "-6:00" for Central, "-7:00" for
8.
Mountain, "-8:00" for Pacific, "-9:00" for Alaska, or "-10:00 for Hawaii; and press "ok".
Press "Exit" button on remote.
9.