Cisco D9854 Installation And Operation Manual page 129

Setup Menu: Outputs,
User Rate (Mbps)
Description:
Parameters:
Output Mode
Description:
Parameters:
Output Mode
No Output
Passthrough
Service Chans Only
MAP Passthrough
MAP Svc Chans
Only
Full DPM Control
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
This parameter controls the output rate. It is only used if Rate
Control is set to User. This setting is used when the signal source is
RF or ASI. Note that output data may be lost when the user-selected
bit rate is set to a value that is less than the actual signal bit rate.
This allows you to set the output bit rate to a value expected by
equipment connected to the ASI output.
0 to 213 Mbps.
This selects the DPM output mode.
No Output, Passthrough, Service Chans Only, MAP Passthrough,
MAP Svc Chans Only or Full DPM Control.
No ASI output will be generated.
The output will be identical to the input. The output
channel will not be modified.
PE/PID remapping options, PSI regeneration and User
Rate are not supported in this mode.
Only service channels will be output.
The output will be identical to the input, except that it
will be generated using the DPM and PID mapping
settings.
Only service channels will be output according to the
DPM and PID mapping settings.
The output will be generated according to the DPM
settings on the DPM: ASI or MOIP1 menus. This is a
manual control setting.
Description
4-67