Cisco D9854 Installation And Operation Manual page 201

Configuring the Transport Stream: DPM Global,
5. In the Remapping Mode drop-down, select the DPM map mode. The following
table describes each mode:
Map Mode
Svc ID
Svc ID & PID
6. Select the Duplication Method of the DPM program, which modifies the PSI to
duplicate a program and its content. This parameter is only used if Remapping
Mode is set to Svc ID & PID. The following table describes the each duplication
method:
Duplic Mode
PSI Remap
Pkt Copy
Pkt Copy is recommended for most applications.
7. Select the DP action to use for Unreferenced Content. Unreferenced content is
the remainder of the transport that is not filtered by the program entries. You
can select Drop All (default) or Pass All.
ASI
MOIP1
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
The elementary PIDs are not changed. Channels are
remapped by changing their PSI references. When this
mode is selected, PE detailed PID mapping cannot be
edited.
Channels and the elementary service PIDs can be
mapped.
Every input PID can be mapped to one output PID. If
PID mapping conflicts exist, DPM will use the
Precedence Rule to decide which output PID to use. All
PMTs using the input PID will be updated to reference
the output PID specified by the winner.
An input PID can be mapped to multiple output PIDs.
The PID will be duplicated as many times as needed (up
to a certain hardware limitation).
Output
Pass, Drop
Pass, Drop
Continued
Description
Description
Unref
5-37