Setting The Dpm Mode - Cisco D9854 Installation And Operation Manual

Setting the DPM Mode

A program can be set to one of three Digital Program Mapping (DPM) modes,
either Drop, Pass or Map respectively. Refer to Setup Menu: Outputs, page 4-62 for
more information on the DPM modes.
LCD Setting
Drop
Pass
Map
To set the DPM Mode:
1. Press MENU to display the Main Menu.
2. Press
3. Press
4. Press
5. Press
6. Press SELECT to access the Global menu.
7. Press SELECT to choose ASI for Resync All.
8. Press MENU. Press
PE1"InCh" and "OutCh" programs.
9. Press
action for the PID associated with the PE. Press SELECT. Press APPLY.
10. Press MENU six times to return to the start-up screen.
1-10 Model D9854 Advanced Program Receiver Installation and Operation Guide
Removes the service and its associated PMT reference from the
transport output.
Permits the source content and PMT reference to appear in the
transport output with the same references unless the source
material is MAPped on another PE.
Provides the flexibility to define all the outgoing PID numbers
for a PE, including those not currently on transmission.
!
to move to the Setup menu. Press SELECT.
!
five times to move to the Outputs menu. Press SELECT.
!
to move to the TS Out menu. Press SELECT.
!
twice to move to the DPM menu. Press SELECT.
!
to move to the ASI menu. Press SELECT. Verify the
!
three times to choose Act. Press SELECT. Use
Description
"#
to select the DPM
4021470 Rev D