Cisco D9854 Installation And Operation Manual page 266

Warning
Temperature
Warning
FPGATemperature
Warning
TDT timeout #
SDT timeout #
6-18
Message Message
Type
Set Temperature over
Warning threshold
Clear Temperature normal
Set Temperature over
Warning threshold
Clear Temperature normal
Set tdt timed out
tdt is lost
Clear tdt fault cleared
Set sdt # timed out
sdt # is lost
Clear sdt fault cleared
Model D9854 Advanced Program Receiver Installation and Operation Guide
Cause/Remedy
Cause: Room temperature
too high, or air flow is
blocked.
Remedy: Check openings
on front and rear panels for
blockage. Lower the room
temperature or improve air
flow to the device.
Cause: Room temperature
is too high, or air flow is
blocked.
Remedy: Check the
openings on front and rear
panels for blockage. Lower
the room temperature or
improve air flow to the
device.
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Description
Temperature is above
normal operating
range.
FPGA temperature is
above normal
operating range.
Time Date Table was
never received.
No longer receiving
Time Date.
Service Description
Table was never
received.
No longer receiving
Service Description.
4021470 Rev D