Changing The Ip Settings - Cisco Prisma II Technical Bulletin

Upgrade Procedure
Pinging the ICIM2
1 From the PC containing SOUP, ping the ICIM2.
2 On the Windows desktop, select: Start -> Run.
Type cmd and press Enter.
3
4 Type ping xxx.xxx.xxx.xxx and press Enter where xxx.xxx.xxx.xxx is the IP
address of the ICIM2.
5 If the response is "Reply from xxx.xxx.xxx.xxx ...", then the connection is good.
If the response is "Request timed out.", then the connection failed, and support
from the IT group is needed.

Changing the IP Settings

The IT group may need to change the IP settings on the ICIM2. The following are
the commands most likely needed to do this.
1 Set IP xxx.xxx.xxx.xxx and press Enter. This will set the IP address of the ICIM2.
2 Set gateway xxx.xxx.xxx.254 and press Enter. This will set the gateway address
of the ICIM2. It is usually the same as the IP address except for the last octet,
which is usually 254.
3 Set subnet 255.255.255.0 and press Enter. This is the most common subnet mask
used. IT should know if a different mask is needed.
4 Reboot the ICIM2 module by pulling it from the chassis far enough to remove
power, re-install module, and wait for the boot process to complete.
5 Go back to Pinging the ICIM2 to re-attempt to ping the ICIM2.
6 78-4032387-01 Rev C