Configuring The Transport Stream: Ts Output - Cisco D9854 Installation And Operation Manual

Configuring the Transport Stream: TS Output

To Set up the Transport Stream (TS) Output
Proceed as follows to set up the TS Output:
1. From the user interface of the D9854, click the Setup tab and then click the
TSOutput icon from the sub-page and select TS Output radio button.
2. There are two different transport stream configurations: ASI and MOIP1. The
following describes both ASI and MOIP1 columns.
Note: Any changes made to the ASI and MOIP1 DPM values will automatically
change the TS Output mode for ASI and MOIP to Full DPM Control.
3. Select the DPM output Rate Control (in Mbps) when using an RF input source
in ASI and/or MOIP1 column. The following table describes the affect each of
the settings has on the output bit rate:
Rate Control
Auto
User
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
The output rate follows that set by the uplink. The
output rate will be the same as the input rate (including
all null packets). This means the output bit rate is
determined automatically based on the input source
symbol rate and FEC value.
The output rate is specified as the Output Rate
parameter. It is determined by the user setting
regardless of the input source.
Description
5-33