Cisco D9854 Installation And Operation Manual page 30

Connecting the Receiver,
7. Connect the HD-SDI outputs (M1 and M2) to HD compatible signal processing
equipment or HD signal monitoring equipment, if applicable.
Maintenance of EMC Compliance
The power cord (consisting of appliance coupler, flexible cord, and plug) supplied
with this product meets the requirements for use in the country for which this
product was purchased. In general, the power cord must be approved by an
acceptable, accredited agency responsible for evaluation in the country where the
product will be used.
Double-shielded (braid/foil or braid/braid) cables should be used for all ASI I/O
and RF inputs. Single-shield cables are acceptable for all other inputs and outputs.
For terminal block (Alarms) I/O, no shielding is required.
1-2 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
4021470 Rev D