Cisco D9854 Installation And Operation Manual page 101

Setup Menu: IP,
Continued
V4/V6
Description:
Parameters:
IP Address
Description:
Parameters:
Mask
Description:
Parameters:
Gateway
Description:
Parameters:
MAC Address
Description:
Parameters:
Multicast Forwarding
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Displays the TCP IP communication protocol version supported on
the Ethernet port.
This value is not editable. Only V4 is currently supported.
Sets the IP Address for its participation in a Network environment.
12 digits in length (###.###.###.###).
Sets Subnet Mask for its participation in a Network environment.
8 to 30.
Sets the Network Gateway Address on the Network, used to expose
the receiver to a WAN.
The IP Address/Mask and Gateway Address should be changed
together, i.e., as a group. The following table shows the most
commonly used Subnet mask values to enter for a chosen IP
address mask, which will depend on the size of your network.
Mask
8
16
24
Displays the MAC address of the receiver. It is set at the factory and
is a read-only value.
N/A.
Sets whether all the MPE data is forwarded to Gateway. It can
forward up to 5 multicast IP addresses.
Note: The Port ID must be set to 2.
Note: The receiver supports up to a maximum of 10 Mbps
throughput when forwarding 1500 byte packets.
Forward None or Forward All.
Subnet Mask
255.0.0.0
255.255.0.0
255.255.255.0
4-39