Cisco D9854 Installation And Operation Manual page 134

Setup Menu: Outputs,
TS/IP
Description:
Parameters:
Min IP/s
Description:
Parameters:
PCR@IP Start
Description:
Parameters:
MGMT Port Mode, DATA Port Mode
Description:
Parameters:
No Output
Always Output
SAP Multicast Address
Description:
Parameters:
PCR Addition
Description:
Parameters:
4-72 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
This selects the maximum number of transport packets per IP
packet.
1 to 7.
This selects the minimum number of transport packets per IP
packet.
0, 2 to 1000.
This selects whether to always transmit a new Ethernet Packet
when a new Program Clock Reference (PCR) arrives.
Yes or No.
This selects the Management and Data MPEGoIP modes.
Note: If No Output was selected for MOIP1 Output Mode, updates
to the port modes will have no affect.
No Output, IGMP or Always Output.
MGMT Mode
DATA Mode
Disables the MPEGoIP interface.
Always outputs data on the port.
Note: You cannot select Always Output for
both ports simultaneously.
This is the SAP destination IP address.
0 to 255 for each of the four fields in the format ###.###.###.###.
This selects whether to add a PCR to the output stream.
Yes or No.
Description
4021470 Rev D