Cisco D9854 Installation And Operation Manual page 151

Setup Menu: Alarm/Warning,
System Alarm Name
Description:
Parameters:
System Warning Name
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Displays a list of the alarm/fault messages. You can scroll through
the list using the UP and DOWN Arrow keys.
Enable - Yes, No. When set to Yes, the alarm message will be
reported. When set to No, the fault won't be reported and the alarm
relays will not be triggered or change state.
Note: Enable must be set to Yes for the Relay and Trap settings to be
functional.
Rly - Yes, No. When set to Yes, the rear panel alarm relay will be
triggered to enable external equipment connected to the alarm port.
Trp - Yes, No. When set to Yes, the SNMP trap message will be sent
to the trap destination; otherwise the fault message will be ignored.
"No*" indicates the trap or relay is enabled, but Enable is set to No,
which will prevent relay or trap operation.
Displays a list of the warning messages. You can scroll through the
list using the UP and DOWN Arrow keys.
Enable - Yes, No. When set to Yes, the warning message will be
reported. When set to No, the fault won't be reported.
Note: Enable must be set to Yes for Relay and Trap messages
reporting to be functional.
Rly - Yes, No. When set to Yes, the rear panel alarm relay will be
triggered to enable external equipment connected to the alarm port.
Trp - Yes, No. When set to Yes, the SNMP trap message will be sent
to the trap destination; otherwise the warning message will be
ignored.
"No" indicates the trap or relay is enabled, but Enable is set to No,
which will prevent relay or trap operation.
4-89